Embroidery

Rose embroidery in satin ribbon

1

Good day to all!

I offer my lesson embroidery  many requests for such a workshop, but only now decided … Do not judge strictly, I am not an expert on such publications)

Hopefully, I will convey the essence and such variations  .Vsё embroidery depends on the imagination, materials, and patience.

So, what we need: fabric for embroidery (my flax), a needle with a wide eye, an ordinary sewing needle with a simple thread, thick needle (to correct tape), do a tape (for this rose tape width of 13 mm) and scissors, hoop.

2

To begin with, to fill in the tape iglu. centimeters long tape diagonally 40.do, the better to thread the belt in an igloo

3

bit and stretch the tape to stick the needle tip, stepping back from the edge of a centimeter

4

like this .Zatem stretch the tape as if tightening the noose

5

Tape securely fixed in the eye of the needle.

6

After, take the free tip of the tape and bend it for about 1 centimeter

7

pierce the needle

8

and stretch the needle through with ribbon bent tip plenty. we are got instead of the usual tie-knot, which we do on the tip of the thread.

9

Lay off to the side while our needle tucked ribbon.

We proceed to the most it will take place in 3 stages.

1) We need to make the central part of the ` cut off a small piece of tape (preferably a shade darker than the main part is embroidered with roses), and do three-dimensional rose.

Wrap the left edge of the tape downwards at an angle of 90 degrees.

10

11

Further, it is necessary to bend the ribbon at an angle from the flower to the outside so that the top edge of the tape has appeared at the bottom, and make a full circle around the tube (core) .Zakreplyaem coil at the base through all the layers of the tape.

12

Again, we turn down the tape down and make new .Tak many turns as your heart desires) The main thing to fix all the turns ordinary  thread, trim it and lent. approximately the rosette

13

2) At the second stage to sew our rosettes conventional filament fabric

14

15

Now, stepping back a few millimeters from the small rosettes-, we take our needle tucked ribbon and piercing the fabric from the inside, pull the needle to the front, fully stretching tape

16

stepping back a few millimeters from the place where the needle came out, inject it into the fabric and stretch down

forming a loop

17

18

We are helping to shape a needle that should turn .

19

Then embroider the petals around
20

21

and that’s what eventually

22

3) The third stage begins in the same way as Prokalyvaem tissue from the inside, having receded somewhat from the first row of petals rose on top, pulling the needle with the tape on the front and embroidery  3-4 lobe same loop

23

24

25

further to rosette looked as if lying on its side, do a little more- tape on the front side, straighten, we do loop

26

stitch and embroider with curls, that is to stick a needle on top of the tape, stretch it down and tightening, forming a curl.

27

28

29

Thus closes the second-row .Ya think, in the process, you will understand how to do the petals to Rose looked more Chem longer will do a loop, the petals will look more magnificent, and rose obёmnee.Lepestochki should try to embroider lying close to each to the friend.

Fix the tape from the inside ordinary thread and tape.

30

It was such a rose

31

And it looks almost finished work

32

Good luck in the works,

Top