CLIP WIRE AND NAIL POLISH

Let’s start

1

We need:
* wire (0,3mm)
* nail polish (preferably not too thick and not too thin)
* wire cutters
* clay
* ballpen

2

we will cut about 5 identical pieces of wire, not very large 8-10sm

3

Bend the wire in half and twists like this

4

to get here is a ring

5

We give it shape petals pressed to handle

6

when viewed from the side, it should turn out like this

7

Now the hardest part:
Generously dip the brush into the paint, stretch big drop from the brush across detail.Ne fact that the bubble will pull lacquer on the first try.
Brush must be kept at the lowest possible angle to the plane of the crafts. Try to keep a brush the top and bottom of the craft. It was easier to do it from the bottom.
Lac taut and burst? Excellent. Now can’t hack in the right direction, that evenly as you need.

8

You can combine colors, but be careful, the bubble could burst!

9

We wait until it dries a little thing, I was drying, sticking petals in a piece of plasticine

10

stamens …. Again, cut into small pieces of wire and gently put on the tip of a drop of lacquer

11

Curl up together … voila! obtain flower)

12

Now a Clip can make a bouquet of flowers))

13

The most convenient way to work with parts whose dimensions are comparable to the size of the brush with nail polish. If the item is much more, it is very difficult to pull at her nail polish.

Leave a Reply

Your email address will not be published. Required fields are marked *