The size of work 30 30 sm.Razor work within the 50 to 50 cm.
Everything is made from paper 125 grams, it is more appropriate for the parrot feathers,
parrot made for this picture.
I print from the printer, plastered on napkins
The beak is covered with varnish and glaze too.
Glazik twisted paper, dropping in the middle of a black paint.
Dimensions feathers Feathers cut and pasted gradually.
As required another.
That was quickly folded together and 4 pieces of paper cut out feathers.
First plastered body feathers since.Potom wings starting from the bottom
The view from the back side. Stick the circle in the middle and the bulk still under the upper wing.
To raise a parrot on the background.
And then a parrot is stuck here
Dimensions branches with flowers. Such branches need to do 2.
In a sprig of flowers 20 (6-7-7) and the other 21 flower (7-6-8)
Initially made midway for flowers.
We need to take a quarter of a strip 3 cm thick on each midway.
Once wrapped in the middle of a red fringed
(The third strip on one flower, the thickness of the strips 1cm)
We need to spread the adhesive flower using a needle to apply glue.
Then dip into the yellow sand for decorations
Spreads flower, shake off the sand that is not stuck.
And the result is such a flower.
Glued wire flowered presses her little seal of paper.
And give good dry.
Wraps brown rubber stamp.
Nestles at the base and continue to wind the paper until the end of the stalk.
Cut a leaf of paper folded in half. I cut out the shape of leaves to the eye.
Then attach the form of an instrument with the ball.
I receive here such leaves.
First goes blank, then folded leaflet and then after leaf
treatment with a ball tool.
And paste leaves behind.
The idea leaves and flowers picked here.
The picture in a frame on the wall.
Thanks to everyone who made it to the end!