Craft Quilling

A TISSUE QUILLING

Pick up for the different tissues of trees appropriate colors. It can be variegated and 2, 3, 4-ply, colorful and simple single layer.

Cut a strip width of 4 cm. White layers can be removed, but you can leave. The result will be a little different.

Fold in half along its length.

Lay down again in half. Ironed fingers.


Take a toothpick, turn a deaf strip (closed) side up. Screw strip on a toothpick.


When twisting the entire strip, remove the toothpick, gently twisting it.


The strip was a little letdown.

Glue the end of the strip. Such napkins blank obtained from one layer of the cloth and the white layers inside (turns thicker). Do a lot of blanks for the crown of the napkins of different colors.

Take the brown napkin (for the trunk). Do the same spiral blank.

pinch the edges. “The Eye” has received the workpiece.

The same make of green napkins for grass under the trees.

Now do the branches and strip outlining the trunk. Cut brown stripes (white layers). Lay down her half.

Gather around and above and below to the target line.

Fold in half and cursed inside the glue stick.

For coniferous trees cut off a strip of green cloth 5 cm thick. If there is a white layer, separating it.

Fold in half lengthwise.

Fold in half crosswise and again in half crosswise.

Make a cut fringe with an open hand.

Not turning, screw on a toothpick. When twisting the fingers is put in the middle of the workpiece to the fringe did not disperse to the sides.

Take a toothpick and Con tips.

Fan the fringe. Before gluing on the basis of the leg can still be trimmed if necessary.

Prepare a base of heavy paper, outline the line of trunks. First glue the blank “Eye” along the large trunk where will be located the hollow.

Glue brown taped blanks between the hollows and on the edges of the tree. Twigs is not glued.

Start glued blanks for crowns. Attaching a small portion, Conn branch and so on.

When the branches and the bottom layer of the crown bonded, glued on top of little circles on the crown.

Glue the next little conifer, reaching it from the fluffy pieces.

Draw the ground under the trees with green leaves.

error: Content is protected !!
Top